Convenient Portable Compact Diesel Generator Super Quiet Electric Start OEM

Mode of operation:

One or more diesel generators that operate without being connected to the grid is called island operation mode. Working generators in parallel can achieve better efficiency under partial load. An isolated plant for the main power supply of an isolated community will typically have at least three diesel generators, any two of which are rated to carry the required load.

Generators can be electrically connected by a synchronization process. Synchronization involves matching voltage, frequency and phase before connecting the generator to the system. Failure to synchronize prior to connection may result in high short-circuit currents or wear on the generator or its switchgear. The synchronization process can be done automatically by an automatic synchronization module or manually by a guided operator. The automatic synchronizer will read the voltage, frequency and phase parameters from the generator and bus voltage while adjusting the speed via the engine governor or ECM (engine control module).

Loads can be shared between generators operating in parallel through load sharing. Load sharing can be achieved by using a descent rate control controlled by the generator frequency, while it continuously adjusts the engine fuel control to transfer the load to or from the residual power supply. The diesel generator will take on more of the load as the fuel supply to its combustion system increases, while releasing the load if the fuel supply decreases.

Standard unit unit:

The standard unit is widely used in the general place of installation in the machine room. The unit is mainly composed of diesel engine, generator, control system, frame, damping device, cooling system, oil supply system, and output protection switch and other parts.

Protective type unit:

Protective units are used in outdoor places where there is no special requirement for noise. It is mainly composed of standard unit, protective cover shell and smoke exhaust system. Since there is no noise reduction device in the protective cover shell, as long as it meets the conditions of ventilation and rain and snow protection, it has a smaller shape and a lower cost. Open doors and Windows for ventilation when the unit is running. The protective power station can be used in parallel with single or multiple sets. The multi-set parallel operation is especially suitable for the occasions with large load changes, high reliability requirements for continuous operation and low cost and economic use, such as supporting oilfield drilling RIGS.

Since establishment in 1985, Guangdong ALI Testing Equipment Co., Ltd, a wholly-owned subsidiary of GSKA Group has been providing a wide and complete range of products and services to the society. GSKA has now 16 offices, warehouses and service centres in China, with head office loCAT-partsed in Hong Kong. There are more than 100 employees in GSKA Group, and we are expanding into many industries with rapid expanding pace of China.

There are mainly 4 departments in GSKA Group, namely:

1) Construction and Mining equipment

GSKA has been cooperating with many international famous brands in China, such as Ingersoll-rand, Atlas Copco and Liebherr. Our products include concrete batching plants, concrete mixers, hydraulic crawler drills, pneumatic crawler drills, water well drills, air compressors, road compactors, breakers and various other equipment. We are major in several industries, such as hydro-electric power plants, cement quarries, coal mines and railway systems.

In order to provide a quick response to our customers, we have stocked over US$1.5 Million spare parts of Ingersoll-rand and Atlas Copco in our Chinese warehouse. Recently, we have exported small air compressors, pneumatic crawler drills, water well drills and drilling accessories and spare parts to overseas market.

2) Power Group

GSKA has been supplying CAT-parts and Broadcrown gensets for more than 15 years. Our major customers include Telecoms, Banks, Airports, Factories and many other sectors in the society. We are also doing assembly of gensets in China, under our brand name of "GSKA " with ratings from 1KVA to 2000KVA. The quality of "GSKA " genset has won a very good reputation from customers in China and overseas market.

We are also the specialists for genuine spare parts, such as CAT-parts, Perkins, FG Wilson, Cummins, , Volvo, etc.

Besides gensets, we also provide total solution on the power problems, such as Powerware - UPS, DC system and battery ,lightning equipment and many other electronic products.

3) Security and IT Group

GSKA acquired famous USA brand name Locktronix in 2004 and started manufacture electric locks in China. Since then, we have been exported products to the Middle East, South Asia and Africa. Our market is expanding each year and we are looking for more distributors in different countries to be our business partners. Besides electric locks and accessories, we have also developed our own access control system by our software team. The system includes smart card solution and also biometric access control, such as hand-key, fingerprint and facial recognition. Our EC-PAYROLL system has been widely used in many factories both in Hong Kong and mainland China.

After all, GSKA has an objective of "Always Provide the Best" and we shall consistently provide high quality products and reliable services to our worldwide customers. We are looking forward to making good business with our partners